Elipta 60w - 12v dc - Potted LED Power Supply in Ground Burial Enclosure
Product No: T9210GB
14 in stock
The T9210GB Ground burial power supply
£108.00
- Product Overview
- More Information
- Downloads
- Reviews
The Elipta 60w - 12v dc - potted LED power supply in ground burial power supply is mounted in a black polycarbonate box and filled with resin, for ground burial.
| Colour/Finish: | Black |
|---|---|
| Dimensions: | L 165mm W 145mm D 84mm |
| IP Rating: | IP67 |
| Construction: | Electronic power supply resin-potted into a black polycarbonate box |
| Input Voltage: | 240v input |
| Watts: | 60 watts. For use with larger L.E.D.s like 5 and 6 watt MR16 L.E.D. lamps |
| Installation: | For surface mounting: Using a slotted screwdriver, rotate each of the 4 quarter-turn corner fixings 90 degrees to the "0" position and remove the lid to reveal the fixing slots in each corner. Secure the transformer to a wall or post with 5mm screws in each corner, or attach to optional transformer mounting stakes. Install the transformer on a wall or post approx. 30cm above ground. For ground burial: Make all connections in T9969 underground joint kit or similar resin-sealed joint. (Boxes with silicon-sealed lids do not protect against ingress of moisture through condensation and capillary action: ordinary silicon sealant does not bond reliably with all enclosure materials.) After burying the transformer and associated junction boxes, lay a paving slab or similar protective material over it, cover with cable warning tape and back-fill hole. NB: Where multiple ground burial transformers are to be installed in an area, allow connection points where possible above ground to allow for isolation in the event of future fault-finding. Connection of transformers to separate cores of a multicore cable may also be considered. Failure to adopt these recommendations may mean difficulty in fault diagnosis in the future and in extending or upgrading the system. |
| Installation | Ground burial |
|---|---|
| Wattage | 60 watts |