The Elipta Modula (stainless steel) is a stylish 12v recessed uplight which takes a choice of 3w - 8w LED lamps. The light is located by an "O" ring on the body into a sleeve tube. To facilitate removal of screws for future relamping or other maintenance, apply copper grease to the threads of all screws being fitted for retention of bezels, grills or other top plates or retaining rings.
Copper grease resists degradation due to heat and guard against difficulty in removing screws, particularly where stainless steel screws are fitted with aluminium parts. It may also be used on screw threads of screw-off bezels or glare shields. Ensure surplus is cleaned off with a solvent to prevent staining in use.
|Colour/Finish:||Stainless Steel finish blends well with modern|
|Construction:||Front bezel is attached to tubular aluminium body. 2m cable via rear entry cable gland|
240v GU10 3w or 5w l.e.d. lamps
The plastic sleeve is built in during construction or retrofitted into a hole cut with a coring bit: the light pushes into the tube, where it is held firmly in place by an o-ring.
Using a single RCD for large numbers of 240v fittings is not recommended due to the risk of nuisance tripping. We advise the use of separate RCD protection for each circuit and a maximum of 12 fittings per RCD. Where a garden lighting installation of more than 12 spike mount or recessed lights per circuit is proposed, we suggest the installation of 12v units with transformers, which results in a significantly higher fault tolerance and reliability in the total installation